I would avoid the SLM2048. We purchased one a few months ago and have had to reboot it 4 times already.
Whenever you get a good amount of traffic going through the switch, connections start dropping, then some ports start going dead until the switch is rebooted. There are other people having problems with this switch as well.
It does not really suprise me that your supplier no longer has the SRW2048, as this switch will be end-of-life soon. But, don't worry, things can only get better, there is a very good and brandnew alternative, the SG 300-52. Actually it has all the features of the SRW2048, and more, better, newer
For more information for the SG 300 series switches, take a look here :
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...