I have two SLM2048 switches I upgraded the firmware on one last week and was planning to put it in to production however the system light (green) continues to blink off/on I have tried to reset the switch, turn it off, etc. nothing seems to make any difference..
The light continues to blink. I have been unable to connect to the switch via the web browser as well.
Your switch may be hung in a system self-test. This may be due to a fw corruption during the upgrade process possibly. I recommend you contact the Small Business Support Center (SBSC) to help you further trouble-shoot the switch and process an RMA if it's determined to be necessary. They can assist you in determining the problem further.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...