I have recently installed a new SLM2048 into our LAN which includes several Linksys switches (SRW2048's) We have been able to trunk VLANs on the SRW2048's but I can't figure out where to set that up on the SLM2048. Could someone please help with this? I have attached screenshots to help with my explanation.
Once you create the vlans, then you need to set the port for trunk or access.
If you set this to a trunk, then you will need to set which vlans are tagged and which vlan is untagged. The untagged vlan is the native vlan, and this setting must match on both ends of the trunk link. Here is an example:
Vlans 1, 10, and 100 are created and the port is set to trunk.
- Vlan 1 is the native vlan and is set to untagged on both switches connected to each other
- vlan 10 and 100 are set to tagged for the same port
It appears that the correct config is to make sure that the port is set to "all" (see page 31).
Then you want the native vlan to be untagged and the additional vlans to be set as tagged.
Try this and see if the vlans and their tags are maintained throughout your network.
In the future, I would suggest a more robust switch when you are performing trunking and all ... these small business switches are great for point products, and simply network expansion, however ... they may not have enough functionality when you are linking a more complex network together.
Even if they will work, they might not be your best choice for a more complex network.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...