Just received a new SLM224P switch to run some SPA942 phones using POE. The switch does not appear to be detecting the POE device. I am using the designated POE ports and have confirmed that POE is enable on all the capable ports - but nothing. I have reloaded defaults and even uploaded the latest firmware and still nothing. I have also tested with a Cisco AP1131AG access point which I know to be working with POE.
For this issue I would go ahead and give a call to the SBSC. Just find the correct number for your locale and give it a call to open up a service request with them since the ports do not appear to be working. If they determine that the device is defective they can tell you how to go about doing an RMA.
You can find the correct number for you in the link below.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...