01-03-2014 07:09 PM
hi everybody i need help my cisco small bussiness SG-500 52P not found command IP ROUTE.
the cause is an electrical cut, my small bussines reset to factory
Solved! Go to Solution.
01-13-2014 05:28 PM
Hi Rafael, can you also verify the switch is in switch or router mode? It is possible when lost power, the config was reverted to the last known config (last time the config file was saved).
-Tom
Please mark answered for helpful posts
01-07-2014 05:04 PM
Hi Rafael, there's not enough information provided. Do you have multiple IP interface configured on the switch? If so, show ip route should display the default routes especially if there is link state on the vlan interfaces.
-Tom
Please mark answered for helpful posts
01-13-2014 05:28 PM
Hi Rafael, can you also verify the switch is in switch or router mode? It is possible when lost power, the config was reverted to the last known config (last time the config file was saved).
-Tom
Please mark answered for helpful posts
01-14-2014 05:10 AM
yeah, the switch is in layer 2
https://mega.co.nz/#!rJ4VjBgS!aG_FMzNjyPxusjfntiMBSyW6C3g8BH9_VuewDcD6QjU
my other switch is in layer 3
https://mega.co.nz/#!OE5hUCiS!DOBkRRB5mQZugcI841iW_XSzLbMcLENRQMa3y9D4ezM
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: