Solve the Duplicate IP error in Cisco SG 500 switch
I am see the following error in the system log of my SG 500 Cisco switch:
%IPADTBL-N-IPDUPLICATE: Duplicate IP address 192.168.0.1 from MAC 00:xx:xx:12:43:2e was detected on VLAN 200, port gi1/26, aggregated (4)
When this error occurs, the PC connected to the WiFi access point on Port 13 (access to VLAN 200) freezes, and it continues browsing after a while. I don't know what causes this error.
The 00:xx:xx:12:43:2e MAC address belongs to my router, and the 192.168.0.1 IP is the IP of the VLAN 200, the IP of the VLAN interface created on the Router, the IP of the default gateway, DHCP and DNS. DHCP is done by the SG 500 which is set in Layer 3 mode, while the DNS is provided by the router.
Do you see any problem in my set up of DHCP pools (see attached pics)?
Maybe there is a problem with my VLAN setup? VLAN 200 is supposed to provide connectivity to guests through wifi AP connected at port 13 (access), VLAN 1 is the native VLAN. And port 26 is the uplink to router set in trunk mode.
[toc:faq]Introduction: This document describes how to connect SG300 with
Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The specification for STP is
IEEE 802.1D. The main purpose of STP is to e...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...