Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SonicPoint on SRW224 G4P

                   I would like to connect a Sonicpoint to an installed Cisco SRW224G4P switch.  Sonicpoints support multiple SSIDs, each on a VLAN.  One VLAN is Corporate (20) another Guest (30).  Guest pointing outward to internet only via firewall rules.  The switch simply has to transport the propriateary Sonicwall protocol (SDP?) over the VLAN, along with DHCP packets, as the DHCP on the VLANS must come from the Sonicwall rather than on the LAN server.

The SonicPoint is connected to port e24, the Sonicwall X0 interface to port e12.

I can see the sonicpoint is operational on the sonciwall, so some communication is happeneing across the switch.  Addtionally, lapstops can see the SSIDs, and connect in a 'mimited' fashion.  IPCONFIG shows no IP address (though inexplicably, it seems a microsfot update occured over night with this setup to the laptop)  DHCP service is set up on the sonciwall fo reach of the VLANs.

FOLLOWING IS VLAN SETUP on the SRW224G4P Switch:

VLAN Mgt>> Create a LAN

     1 default Static

     20 SpoinpointN Corporate       Static

     30 SonicpointN Guest             Static

VLAN Mgt >> Port Setting

     Port e12 TRUNK PVID=1 Ingress Filter Enabled

     Port e24 ACCESS PVID=20 Ingress Filter Enabled

VLAN Mgt >> Ports to LAN

     VLAN1, Static

          Port e12 Trunk Untagged

          Port e24  Acess Untagged

          OTHERS Access Untagged

     VLAN20 Static

          Port e12 Tunk Tagged

          Port e24 Access, Excluded

          OTHERS Access Excluded

     VLAN30 Static

          Port e12 Trunk Tagged

WHERE AM I GOING WRONG?

          Port e24 Acess Excluded

Everyone's tags (4)
336
Views
0
Helpful
0
Replies
CreatePlease to create content