Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRW 2024 v1.1 - frw 1.2.2b (Qos Mode ? advanced)

Hello

SRW2024 v1.1

Model Name  SRW2024
Hardware Version  00.03.11
Boot Version  1.0.1
Firmware Version  1.2.2b

Hello, i would like to use Advance qos mode

I can select Qos Mode : Basic / Disable.

How select advanced mode QoS ?

The documentation

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2048/administration/guide/SRW-US_v10_UG_A-Web.pdf

page 40 (in the documentation):

The CoS Settings screen has two areas, CoS Settings and CoS to Queue.

QoS Mode Indicates if QoS is enabled on the interface.

The possible values are:

    •• Disable Disables QoS on the interface.

    •• Basic Enables QoS on the interface.

    •• Advanced Enables Advanced mode QoS on the interface. This feature has been added to version 1.2 of the SRW2024/SRW2016 and version 1.1 of the SRW224G4/SRW248G4.

SRW2024 Firmware Revision History :

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2016_srw2024/release/notes/SRW2016-24-hw1.3_RN_v1.2.2b-tm.pdf

5. QoS --> Advanced Mode

(a) When configuring a policy with police - exceeded action - out of profile dscp, the policy must have an action: trust cos-dscp or set dscp. If you configure a policy with police - exceeded action - out of profile dscp without an action - the device configures the action to trust cos-dscp. If you configure a policy with police - exceeded action - out of profile dscp with an action set cos/queue, the device configures the action to set dscp 0.

Best regards

Thank you

  • Small Business Switches
Everyone's tags (5)
1 REPLY

SRW 2024 v1.1 - frw 1.2.2b (Qos Mode ? advanced)


Hello Mr Picard,

I see that you have a SRW2024 v1.1.
Unfortunately at this point is not possible to use the Advance Qos mode on this kind of devices.
As you can see on the documentation found.
This option is only available for equipmets from the version 1.2 onwards

http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2048/administration/guide/SRW-US_v10_UG_A-Web.pdf

627
Views
0
Helpful
1
Replies
This widget could not be displayed.