SRW 2048 1.2.1 Firmware missing from Cisco's site?
I've got a Linksys SRW 2048 and after updating the firmware to 1.22d it goes into a boot loop on console. Downgrading to 1.22 from cisco's site (via xmodem on the console) does the same thing. How do I get my hands on a copy of the 1.2.1 firmware that was on this thing when it would actually boot?
Re: SRW 2048 1.2.1 Firmware missing from Cisco's site?
I'm sorry to hear that you've had trouble with the switch firmware. If you need previous FW versions that aren't provided on the Software Download page, you will need to open a case with the Small Business Support Center. They can help you to further troubleshoot your issue and provide you with any previous versions shold it be necessary.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: