Creating multiple VLANS with SRW2024 - 15 to be exact allow all VLANS to get out to the Internet but restrict access to each other. Each VLAN has 1 PC connected, so each PC is it's own VLAN. I have been successful with creating the VLANS but I'm having problems with allowing all vlans to get access to the Internet. I need away to point all VLANS to the same gateway. Can this bee done - if anyone has been successful with this type of setup , I'm open ears.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...