I just put a nice SRW2048 into our network but can't seem to get Webview running on Safari or Firefox on OSX Leopard. Is this a common problem? Is there a fix? I can access it fine using Internet Explorer under Parallels, but would really prefer Safdari or Forefox on the Mac.
Viewing the Web Interface of any Linksys equipment with a Mac is officially not supported. However, it has been found that the Opera web browser for Mac will work on later hardware revisions such as the SRW2024 version 1.2.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...