Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRW224G4 - POST - Fail

Hi,

I have a Linksys SRW224G4 with me. I have successfuly connected the switch with console.

When i reboot the switch, it shows me something like this.

------ Performing the Power-On Self Test (POST) ------

UART Channel Loopback Test ......................... FAIL

After this message nothing comes up, its like the switch gets hanged up.

Sometime it actually works, but when it says " Autoboot 2 seconds to press ESC or RETURN" and even if i press ESC or Enter, nothing happens. Later on the switch reboots again by itself.

Can anyone help me out in this matter.

Basically i forgot the password which i had set about 6 months back, now i am stuck.

Looking forward for a quick and positive reply.

2 REPLIES
Bronze

Re: SRW224G4 - POST - Fail

If it is still under warranty, I would suggest calling our support center.

You can find the links for the support center on this page, look to the right hand side of the web page:

https://www.myciscocommunity.com/community/smallbizsupport

HTH,

Andrew Lissitz

New Member

Re: SRW224G4 - POST - Fail

Dear,

Thanks for the reply. The switch is not in warranty any more. Can it be fixed or not.

515
Views
0
Helpful
2
Replies