We finally got around to sending our broken SRW248G4 back to Cisco, which they promptly replaced (well done ),
However, when i got it back, i decided to deploy the latest firmware - v126.96.36.199 from the Cisco downloads site, the upgrade went well but on starting up i am now no longer able to access the web UI config interface - i get the problems i previously had before applying the IE workaround bug. No amount of fiddling with IE settings and versions managed to make it work.
OK i thought, that firmware is broken, i'll downgrade. Downgraded with the console interface and TFTP - v1.2.2b - downgrade went well, however the web UI still doesn't work.
On our other identical switch v1.2.2b works fine so i can't understand what's wrong.
Anyone any ideas? I tried two firmwares and factory resets to no avail.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...