05-10-2010 01:50 AM
Hello
I have switch SRW248G4. And he has issue with load configuration. I loaded firmware but without any result. Please help. I placed below logs from booting device.
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test........................PASS
Testing the System SDRAM..........................PASS
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
BOOT Software Version 1.0.2 Built 17-Aug-2006 14:55:46
:::
::: ::: ::: ::: ::: ::::: :::::::::: ::: ::: ::::::::::
::: ::: ::::: ::: ::: ::::: :::: ::: :::: :::: :::: :::
::: ::: ::: ::: ::: :::::::: :::: :::::::: ::::
::: ::: ::: :: ::: :::::::::: :::::::::: :::: ::::::::::
::: ::: ::: :::::: ::: :::: ::: :::: :::
:::::::::: ::: ::: :::: ::: :::: :::......::: :::: :::......:::
......... ... ... ... ... .... .......... .... ..........
Linksys SmartSwitch based on 88E6218 with ARM946E-S.
32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...
100%
Decompressing SW from flash
100%
OK
Running from RAM...
*******************************************************************
*** Running SW Ver. 1.2.1b Date 31-Aug-2006 Time 13:47:21 ***
*******************************************************************
HW version is 00.03.00
Base Mac address is: 00:1a:70:2b:f6:58
Dram size is : 32M bytes
Dram first block size is : 16969K bytes Dram first PTR is : 0xF6D840 Flash size is: 8M
01-Jan-2000 01:01:02 %CDB-I-LOADCONFIG: Loading startup configuration.
01-Jan-2000 01:01:04 %ERHG-F-SEND: BOXP_perform_smi_scan_of_devices_in_slot - fa iled reading device id on device 0
***** FATAL ERROR *****
Reporting Task: ROOT.
Software Version: 1.2.1b (date 31-Aug-2006 time 13:47:21)
05-10-2010 09:11 PM
I would suggest to call support. Is this unit under warranty still?
From this main page, you can find a link on the right hand side for the support numbers:
https://www.myciscocommunity.com/community/smallbizsupport
HTH,
Andrew Lissitz
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide