Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRW248G4 issues

Hello

I have switch SRW248G4. And he has issue with load configuration. I loaded firmware but without any result. Please help. I placed below logs from booting device.

------ Performing the Power-On Self Test (POST) ------

UART Channel Loopback Test........................PASS

Testing the System SDRAM..........................PASS

Boot1 Checksum Test...............................PASS

Boot2 Checksum Test...............................PASS

Flash Image Validation Test.......................PASS



BOOT Software Version 1.0.2 Built  17-Aug-2006  14:55:46

:::
:::        ::: :::       ::: :::     :::::  :::::::::: :::      ::: ::::::::::
:::        ::: :::::     ::: :::   :::::   ::::     ::: ::::  :::: ::::     :::
:::        ::: ::: :::   ::: ::::::::      ::::          ::::::::  ::::
:::        ::: :::   ::  ::: ::::::::::     ::::::::::     ::::     ::::::::::
:::        ::: :::    :::::: :::    ::::            :::    ::::             :::
:::::::::: ::: :::      :::: :::      :::: :::......:::    ::::    :::......:::
......... ... ...       ... ...       .... ..........     ....     ..........

Linksys SmartSwitch based on 88E6218 with ARM946E-S.
32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...
100%
Decompressing SW from flash
100%

OK
Running from RAM...

*******************************************************************
*** Running  SW  Ver. 1.2.1b  Date  31-Aug-2006  Time  13:47:21 ***
*******************************************************************

HW version is 00.03.00
Base Mac address is: 00:1a:70:2b:f6:58
Dram size is  : 32M bytes
Dram first block size is  : 16969K bytes Dram first PTR is  : 0xF6D840 Flash size is: 8M
01-Jan-2000 01:01:02 %CDB-I-LOADCONFIG: Loading startup configuration.
01-Jan-2000 01:01:04 %ERHG-F-SEND: BOXP_perform_smi_scan_of_devices_in_slot - fa iled reading device id on device 0


***** FATAL ERROR *****
Reporting Task: ROOT.
Software Version: 1.2.1b (date  31-Aug-2006 time  13:47:21)

  • Small Business Switches
1 REPLY
Bronze

Re: SRW248G4 issues

I would suggest to call support. Is this unit under warranty still?

From this main page, you can find a link on the right hand side for the support numbers:

https://www.myciscocommunity.com/community/smallbizsupport

HTH,

Andrew Lissitz

365
Views
0
Helpful
1
Replies