Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

srw248g4p - boot image needed (boot.bix)

Hi to all,

I have 48 port Linksys switch srw248g4p. It stopped working after power failure. When i connect via hyperterminal i got this

#####################################################################

Image Loader 1.0.1

<ERR> Diagnostic Loading Fail - Try Runtime

Loading Runtime Image File : SRW224G4P_SRW248G4P_image.bix

Runtime 1.0.2

....................

Please press <Enter> to start Menu session!

#######################################################################

It boots normally to runtime image and i can access main menu, but i still need diagnostic/boot image to work (i still can't access web view and all eth ports are down). Where can i find "SRW224G4P_SRW248G4P_boot.bix" ? Can someone send it to me?

Thank you !

6 REPLIES

srw248g4p - boot image needed (boot.bix)

Hi Emilije,

You can download the firmware from the software download center.

If the link doesn't work, just search for the model #.

Best,

David

Please rate helpful posts.

New Member

srw248g4p - boot image needed (boot.bix)

Hi David,

Thank you for your reply. Please note that i already have this image and i need boot code/boot image/diagnostic image.

This firmware in your link is something different than boot code. Have in mind that in order to work properly SRW248G4P must have both images loaded. Since Linksys support migrated to Cisco there is no more boot code avalible for download (THANK YOU CISCO), that's why i'm posting this anyway.

Once again, i need file with this filename: SRW224G4P_SRW248G4P_boot.bix which is different image than

SRW224G4P_SRW248G4P_image_VERSION.bix.

best regards,

emilije

srw248g4p - boot image needed (boot.bix)

Hi Emilije,

Sorry,  I got excited when I saw the firmware in the download center...  Have you tried contacting Small Biz Support?

Best,

David

New Member

srw248g4p - boot image needed (boot.bix)

well, cisco support engineer told me that boot image does NOT exist, and only thing i need is firmware

available from download center. No comment.

If someone have the same switch and can download image via webview i would appreciate it ( admin - firmware upgrade - option backup - option image / option boot code + you will need some basic tftp)

in the meantime ill try to find same switch at some other customer and download it by myself.

thank you

New Member

srw248g4p - boot image needed (boot.bix)

New Member

srw248g4p - boot image needed (boot.bix)

How i can upload SRW224G4P_SRW248G4P_boot.bix to my switch by XMODEM ? As runtime ?

1946
Views
0
Helpful
6
Replies
CreatePlease to create content