Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRW248G4P in constant boot loop.

I just purchased this SRW248G4P switch, powered it up and initially I was able to get into the console port and perform initial configurations.  I connected another switch to one of the Gigabit ports and performed my configuration changes via the web browser.  Upon reboot, it went into a constant diagnostic reboot loop below.  Any ideas on what I can do to fix this, or am I talking RMA?

Image Loader 1.0.1
Loading Diagnostic Image File : SRW224G4P_SRW248G4P_boot.bix
Diagnostic 1.0.1


Image Loader 1.0.1
Loading Diagnostic Image File : SRW224G4P_SRW248G4P_boot.bix
Diagnostic 1.0.1

Thanks,

Chris B

1 REPLY

Re: SRW248G4P in constant boot loop.

Ah Chris,

I hope we are not talking about RMA, costs us both time and money.

Give the good folk at the Small Business Support center a call via the following URL.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

regards Dave

471
Views
0
Helpful
1
Replies