I have 2 SG500XG-8F8T switches and 3 SG500 switches. each set up in there own stack Currently SG500 running at 5G and SG500xg running at 10G between them.. with a 1G connection connecting the 2 stacks. Is there a way to get all 5 switches in the same stack running at 5G? Or would I have to create a LAG to get the additional bandwidth between stacks.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...