Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Switch SG300 / WLAN Controller 2504 / AP 3702

I would like to use the Existing Firewall with DHCP Server.
There are 2 Network
192.168.0.1 admin
192.168.10.1 edu
 
There is a Problem that i do not get a IP Address on the WLAN Client. 
Would appreciate a good Tipp.
 
Current Configuration
Cisco Switch SG300-28PP IP http://192.168.0.10
Cisco WLAN Controller 2504 IP http://192.168.0.11
 
SG300-28PP
VLAN Settings
VLAN ID 1
VLAN ID 200 edu
Port VLAN Membership
Interface=GE 1 ( Connected to Firewall existing admin Net)
Mode= Trunk
Adminisrative VLANs Trunk 1UP
Operational VLANs Trunk 1UP
Interface=GE 2 ( Connected to Cisco 2504 Management Port)
Mode= Trunk
Adminisrative VLANs Trunk 1UP, 100T
Interface=GE 19 ( Connected to Firewall existing edu Net)
Mode= Access
Adminisrative VLANs 200UP
Operational VLANs Trunk 200UP
Interface=GE 7 ( Connected to AP 3702)
Mode= Trunk
Adminisrative VLANs Trunk 1UP, 200T
Operational VLANs Trunk 1UP, 200T
 
 
Cisco 2504 WLAN Controller
WLANs
Profile Name=admin WLAN SSID=admin
Profile Name=edu WLAN SSID=edu
Controller
Interfaces Name= management
VLAN Identifier= untagged
Controller
Interfaces Name= edu
VLAN Identifier= 200
 
 
 
Thank you for your Advice.
Manfred
 
Everyone's tags (1)
1 REPLY
New Member

Hi, computer_studio... From

 

From my understanding wireless clients are unable to receive DHCP information from the firewall/router.. iam unsure what Vlans are for your wireless  clients. To make this work firewall/router would have to be aware of all subnets/vlans. Your uplink to the SG300(Interface=GE 1 ).  Is there another uplink (interface=19)to the same firewall/router or a different one? If its the same firewall then you could go only with uplink Interface=GE 1 and tag all vlans accordingly, Interface = GE 1  1U, 100T, 200T. Let me know if you have further questions on this .

219
Views
0
Helpful
1
Replies
CreatePlease to create content