Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hi,

I have several SG300-10 and SF302-08P switches running with L2-mode, and after I upgraded their firmware to 1.1.2.0, they began to record the following logs every one hour.

- Severity: Warning

- Description: %COPY-W-TRAP: The mirror-config file is illegal due to failure of previous copy operation/s to mirror-config.

Also I found that I didn't see the Mirror Configuration file on the Configuration File Table in the Configuration Files Properties page.

I have had no problem so far but I don't think I can leave this situation as it is. Can someone give me any advice what I need to do, please?

Thanks

Everyone's tags (4)
6 REPLIES
New Member

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hi Akio,

I have the same issue on a SG300-28 upgraded to firmware 1.1.2.0.

Any advice from you or Cisco ?

Many thanks

Bronze

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hello all,

Can one or both of you call into the support center at 1-866-606-1866 and create a case, so we can better support this issue. We are interested in finding a quick solution for your problem, but we need to gather the information, so we can resolve this problem.

Thanks,

Cisco Small Business Support Center

Randy Manthey

CCNA, CCNA - Security

New Member

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hello Randy,

I would like to contact the support center by e-mail instead of phone if it's possible.

Thanks

Bronze

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hello Akio,

We have a chat option that allows for real time support.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

Cisco Small Business Support Center

Randy Manthey

CCNA, CCNA - Security

New Member

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hi Randy,

Thank you for your reply. I will try it later.

Thanks

New Member

Sx300 - Missing Mirror Configuration on Firmware 1.1.2.0

Hi Jean-Philippe,

I have not worked out this issue yet.

In my environment,

- two out of three L2-mode SG300-10 express the logs.

- two L3-mode SG300-10 have no problem.

- one L2-mode SF302-08P expresses the logs.

- one SG200-50 has no problem.

All of the above are running with firmware 1.1.2.0.

Regards

1458
Views
0
Helpful
6
Replies