Why does the sx300 series only displays ping and traceroute results in 20ms intervals (see below)? The example in the CLI manual shows "regular" results. These 20ms intervals are not helpful for troubleshooting. This is version 184.108.40.206 on an sf300-24.
Sorry for the delay in getting a response to you. I have seen where the Sx300 series does show a rounded result which is normal when troubleshooting from the switch. If you must have times showing exactly, then I would suggest running the pings from an attached computer.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...