Ringraziandovi anticipatamente per l'attenzione vorrei chiedere un consiglio su come testare il throughput di alcuni switc Linksys by Cisco System, che abbiamo in azienda.
In particolar modo abbiamo dei SRW2048, SRW2024p, SG200 50. Dopo aver dato dei malfunzionamenti sono stai aggiornati con l'ultimo firmware disponibile, ma prima di rimetterli in produzione vorrei la certezza che, gli switch, siano perfettamente funzionanti.
Ho provato ad usare ttcp, ma ho capito che è compatibile solo sui I'os Cisco System. Io vorrei provare la funzionalita non solo delle porte RJ45, ma vorrei provare il processore dello switch per simulare il massimo impiego a regime. Sapreste indicarmi dei software o dei comandi per fare questo?
Thanking you in advance for your attention I would like to ask for advice on how to test the throughput of some switches Linksys by Cisco System, which we have in the company.
In particular, we have SRW2048, SRW2024p, SG200 50. After giving malfunctions are you up to date with the latest firmware available, but before putting it back into production I would like to be sure that the switches are functioning properly.
I tried to use ttcp, but I realized that it is only compatible on I'os Cisco Systems. I would like to try not only the functionality of the RJ45 ports, but would like to try the processor switch to simulate the maximum at full capacity. Can you tell me any software or commands to do this?Thanking you in advancefor your attentionI would like toask for adviceon how to testthe throughput ofsome switchesLinksys byCiscoSystem, whichwe havein the company.
In particular,we haveSRW2048,SRW2024p,SG20050.After givingmalfunctionsareyouup to date withthe latest firmwareavailable, butbefore putting it backinto productionI would like tobe surethatthe switchesare functioning properly.
I tried to usettcp, but Irealized that it isonly compatibleonI'osCisco Systems.Iwould like to trynot onlythe functionalityof theRJ45 ports,butwould like to trythe processorswitchto simulate themaximumat full capacity.Can you tell meany software orcommandsto do this?
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...