Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

The POE-IN on SG200-08?

I do not find much information about the POE-IN port 1 on the SG200-08. Will I be able to power a SG200-08 switch from a POE port on a SG200-26P?

Everyone's tags (2)
5 REPLIES
Green

The POE-IN on SG200-08?

Hi Ivar, yes, this switch does have a function to power another sg200-8 with POE via port.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Gold

The POE-IN on SG200-08?

Ivar,

The SG200-08 is designed to be powered by PoE when used in remote locations where AC power is not available.

- Marty

New Member

Is it anywhere documented on

Is it anywhere documented on which type of POE Input voltage is needed for this switch?

The question is because I do have a 24v POE injector that I'd like to use to power this switch, but in the specifications this switch is supposed to receive only 12v.

Any recommendations? Will I burn the switch if I connect a 24v POE injector in port 1 ?

 

Tks for your help

Diego

Gold

Hi Diego, The 12V input is

Hi Diego,

 

The 12V input is for a power supply (wall wart). The switch will negotiate with the PoE injector and get the power that it needs. It should work without issues as long as the injector is standard.

 

- Marty

New Member

The injector I'm planning to

The injector I'm planning to use is the one that comes with a Ubiquity Access Point.

It's described here: http://www.ubnt.com/accessories/poe-adapters/

 

1025
Views
6
Helpful
5
Replies