I was reconfiguring this switch and taking LAG/LACP off of Gi1 and Gi2. After I did this I am unable to hit the web interface. I have also tried connecting to the switch with a serial cable, with 38400 8 n 1 n, and cannot bring up the console. Any suggestions on getting back into some kind of configuration?
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...