Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Upgrading SG300 firmware from 1.3.5.58 problem

Hello,

We have two new SG300 managed switches. I've upgraded the firmware from the stock to 1.3.5.58 with no problem but when I go to upgrade to the newest firmware - 1.4.x I get the following error on both switches:

Files Transferred:  7011840 
Status:  Copy failed 
Error Message:  Copy: SW code file is over sized 

Any idea what is wrong? I can't find any option to delete older images. Thanks,

 

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Hello, do you do the upgrade

Hello,

 

do you do the upgrade through the web interface? I did the upgrade from 1.3.7.18 without any issues.

What is your bootloader version? "Show version" on the command line.

 

kind regards

Lukasz

Cisco Employee

Check out this post it

Check out this post it appears to be the same issue.

 

https://supportforums.cisco.com/discussion/12285601/cisco-sg200-50-gigabit-smart-switch-cant-upgrade-fw

4 REPLIES
New Member

Hello, do you do the upgrade

Hello,

 

do you do the upgrade through the web interface? I did the upgrade from 1.3.7.18 without any issues.

What is your bootloader version? "Show version" on the command line.

 

kind regards

Lukasz

Cisco Employee

To upgrade the bootloader

To upgrade the bootloader through TFTP server on the GUI, see details in 

http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=f1e39061efb14c94a570bcbd6582167b_Firmware_Upgrade_Troubleshooting_on_300_and_500_Series_Manag.xml&pid=4&fcid=&fpid=&slnid=6

 

Cisco Employee

Check out this post it

Check out this post it appears to be the same issue.

 

https://supportforums.cisco.com/discussion/12285601/cisco-sg200-50-gigabit-smart-switch-cant-upgrade-fw

New Member

Yes, thanks to both of you

Yes, thanks to both of you for pointing me in the right direction. I missed the readme note that said you had to upgrade the bootloader to a higher version. Once I did that with tftp I was able to correct the problem. Thanks again.

1031
Views
0
Helpful
4
Replies
CreatePlease to create content