I got a used Linksys SRW248G4 from a friend of a friend. I am trying to get into the administration panel and the password seems to be changed from the default. I also can't seem to get into the console (Windows 7 x64, keyspan USA-17HS, putty, 38400,8,None,1,None). Is it possiable to disable the console? Is there some sort of jumper inside that I can short out to reset the password? All I am getting is a blank window in console so the POST password reset method won't be all that effective unless I can get the console to work. Any ideas?
I'm sorry to hear you are having problems with the device.
I think you should be able to use the console no matter what. Are you absolutelly sure that the com port you are using is the right one? can you connect any other device to that same com port and access it? I would check that first.
Then if you are completely sure that you have all the appropiate settings and still are getting a blank screen then I'm affraid you are out of lock. Maybe the console port is broken and the fact that you dont know the new password will made this device no more useful than a brick.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...