I have a network setup with a SA-520 firewall appliance, and a SLM2008 switch. I'm trying to confgure this with multiple vlans. On the SA-520 I've configured port 4 as a trunk with vlan's 1,2 and 4.
But I'm unable to get this to work with the SLM2008. I would like to configure port 1 on the SLM as trunk with vlan's 1,2 and 4. Port 4 and 5 should only have traffic from vlan 4 and port 6 and 7 should only have vlan 2. But I'm not able to get this to work.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...