why the hell do i have to sign in to review the release notes for the newest firmware update/release? moreover, why do i get a 403 Forbidden page, after i do sign in? what brain dead asshole is pushing this policy? how do i know if the newest firmware addresses issues that i might have encountered if i cant read the fucking release notes? again, what asshole is in charge of the thoughtless decisisons? the idea that i have to sign in is rediculous, and the fact that i cant read them once i do jump through the hoop is insult on top of injury.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...