WRP400 - help needed - access to outside network gets hampered
I have a WRP400 VOIP Cisco router.... it is slowly driving me demented.
The WRP400 seems to hamper my ability to access outside the network over time. If the router is plugged in for an amount of time, my broadband (35mb UPC) gradually tapers down to nothing. As soon as I restart the router, my broadband access shoots back up to the full 35mb.
I've been on to UPC numerous times, they say their connection is stable & good..... must be router.
I have a DVR (security camera system) that when plugged into the WRP400, seems to exacerbate the issue. It normally takes the router two few days to hamper internet access...... when I plug-in the DVR internet access goes from 35mbps to 0.5mbps in a few hours.
I've update the Firmware to the latest Version: 2.00.26
Anyone gone any ideas of what could be causing this?
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...