Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Wall Mount the WAP150 Access Point

Objective

The WAP150 Wireless-AC/N Dual Radio Access Point with PoE can be physically installed in two ways:
  1. Horizontally place the WAP150 on a flat surface.

  2. Wall mount the WAP150.

This article provides instructions on how to mount the WAP150 using the wall-mount slots on the bottom cover.

Note: The wall-mounting accessories are user-supplied.

Applicable Devices

  • WAP150

Software Version

  • 1.0.0.13

Wall Mount your WAP150

Placement Tips

  • Ambient temperature should not exceed 104°F (40°C) to prevent the WAP150 from overheating.

  • Ensure adequate air flow around the device.

  • The WAP150 should be level, stable, and secure to prevent it from sliding or shifting out of position.

Wall Mount your WAP

Caution: Insecure mounting might damage the device or cause injury. Cisco is not responsible for damages incurred by insecure wall-mounting.
Step 1. Determine where you want to mount the WAP150.

Step 2. Drill two pilot holes into the surface 3-5/8” (92 mm) apart from your WAP.

Step 3. Insert a tox (1-2) into each hole, leaving a gap between the surface and the base of the tox head. Below are the dimensions:
  • 1 — .32 in/8.0 mm

  • 2 — .87 in/22.0 mm


Step 4. Insert a screw (3-4) into each lower hole. Below are the dimensions:
  • 3 — .26 in/6.5 mm

  • 4 — 0.69 in/17.4 mm


Step 5. Tighten each screw and leave a gap between the surface of the wall and the head of the screw.

Step 6. Slide the WAP into the screws. Tighten or loosen the screws as needed for a perfect fit.
You should now have successfully mounted the WAP150 on the wall.
 
Version history
Revision #:
1 of 1
Last update:
‎07-07-2016 03:52 AM