cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
760
Views
0
Helpful
3
Replies

Cisco UC520 Configuration

lee.woods16091
Level 1
Level 1

Hi Guys, 

 

i have recently purchased a cisco uc520 which hasn't yet arrived, 

 

i'm struggling to find any information on configuring this device, i'm not familiar with the command line interface. 

is there any other way of configuring the device or can anyone help with the command line side of things? 

 

thanks in advance :) 

 

Lee 

3 Replies 3

Brandon Buffin
VIP Alumni
VIP Alumni

You can find Getting Started/Quick Start guides here:

https://www.cisco.com/c/en/us/support/unified-communications/unified-communications-500-series-small-business-uc500/products-installation-guides-list.html

 

One option is to use Cisco Configuration Assistant to configure. CCA has a GUI interface and can configure the basic components (DNs, call routing, VM, etc.)

https://software.cisco.com/download/release.html?mdfid=281010085&softwareid=281161599&release=3.2(3)&relind=AVAILABLE&rellifecycle=&reltype=latest&i=rm

 

As I'm sure you are aware the UC520 and CCA are no longer Cisco supported products.

 

Brandon

hi Brandon, 

 

do you havce any idea on how i connect the uc520 with the configuration assistant without a console cable? 

 

regards, 

 

Lee :) 

The default configuration of the UC520 has a DHCP server configured to hand out addresses in the subnet 192.168.10.1/24. You would connect your PC to one of the switchports and connect to 192.168.10.1 via CCA. If the default config has been wiped, you will need to connect via console cable to assign an address and setup a username/password before connecting with CCA.

 

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: