I'm in need of some help, with what I hope is an easy problem.
We recently purchased an Aironet 521G Access Point. I cannot connect to this thing to configure it at all. Ive tried the browser, I've tried the Configuration Assistant (ver 2.2), and everything says it cannot connect.
I have consoled into it, and can see it has an IP Address via DHCP. I can even ping that, but that is all. Unfortunately from what I've read for the past two days, I cannot program the AP via the CLI. I've tried a bunch of things from other posts, but no joy.
Can someone please throw me a few hints here? Could it be a faulty AP?
I'm very well versed in Cisco and feel like a fool for not being able to access a simple AP.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...