My customer owns a coffee shop that offers free wifi to their customers. Right now, I have all residential Linksys stuff deployed but am upgrading to the Cisco RV180 router. I was going to use Unifi access points but don't want to use a controller as no dedicated PC will be on the free wifi subnet. Unfortunately, the Unifi APs were less than $100 each. My customer cannot afford the Aironet models. Cisco has a WAP line. Are they any good? Past that, any othe manufacturers in the $100 or so range? Thanks
Sounds good. I'm thinking I'll leave the Linksys WRT54G access points in place until I get the RV180 settled in and working. As easy as my setup appears to be, I'm unfortunately not expecting the swap to go quiclky and seemlessly. Thanks
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...