Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIR-CAP2602I-A-K9 convert to Autonomous mode

I have managed to get a static IP on the box.  However, when I go to access it from the web interface I get the following message:  "The AP is not in Flexconnect mode.".  I have searched for instructions on turning on Flexconnect.  However, all of the instruction for the CLI are the same and do not tell what mode you have to be in to execute these commands. I have not been able to get the "config AP Mode Flexconnect" command to work or even what mode I need to be in to execute  it.  I do not want to us a controller to manage this AP.  Can someone help me with this issue?

2 REPLIES
Hall of Fame Super Gold

Using a TFTP Server to Return

VIP Purple

Hi John,1. First you must

Hi John,

1. First you must download the right image from cisco.com.

K9w7  - Autonomous Image

k9w8 - Lightweight Image

More info about images:http://rscciew.wordpress.com/2014/01/04/understand-access-point-ios-images/

Here ius the link to download Autonomous image for this AP:http://software.cisco.com/download/release.html?mdfid=284362257&flowid=34153&softwareid=284180979&release=15.2.4-JB5&relind=AVAILABLE&rellifecycle=ED&reltype=latest

2. How to convert from LAP to Autonomous:

https://www.youtube.com/watch?v=QQ_NuxdRhQ4

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

 

Hope it helps.

Regards

Dont forget to rate helpful posts

496
Views
0
Helpful
2
Replies