Premier Partner set-up new AP541N's and we're having difficulty connecting with WPA2 with our Dell Latitude E4300s using the Dell Wireless Utility. Our Latitude D600/630's successfully connect with WPA2 via WZC.
The E4300 start @ IP127.x.x.x, run 'acquiring network address', then show connected to IP 169.x.x.x. The D600/D630's start @ IP127.x.x.x, run 'acquiring network address', then show connected to IP 192.x.x.x and users successfully connect to the LAN and internet.
Anyone else having issues with AP541N's v1.7.0(2) and Dell wireless utility?
Update. Dell Latitudes successfully connect with security set to 'None'. Set security to 'WPA Personal' with only WPA checked ( WPA2 not checked ) and users were prompted for password, user enters the password and connects. The following day, same security settings with new password and both previous day's users and new users are not prompted for a password and are unable to connect. Set security to 'None' and all users connect.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...