I have MANY unanswered questions with respect to the Microcell; and, Cisco will not answer (i.e. supported by AT&T) even though tier 2 Business Data Support is unable to assist at AT&T.
What I CAN suggest is the following: I have a bandwidth manager (free no charge/freeware) and once you install it, in addition to the icon in your tray/right side, you can right-click on the taskbark and "add" the "networx desk band" which is a real-time graph/you can see how it "spikes" during a call etc.
This software is available from the following site/vendor:
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...