Hello!
This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful.
Virtual Assistant- Discover support content and options for your gearSupport page index - Contains a ...
My only working solution for now... put digital timer switches on the power plug to kill/reboot the AP at 5am so it hopefully survives the day's traffic before going unresponsive again. Pretty sad solution for a product of this brand/price.These wor...
Hi,We have setup a bridge between two of our offices using two WET200's in adhoc mode. Everything is connected fine and the signal strengh is good. All traffic pass's over the bridge correctly but DHCP requsts/replys seem to be failing to travers...
I'm trying to setup our system to provide clients/customers/vendors to have wifi access on our network, but keep them separated from our corporate LAN. I have two WAP4410N WAPs, an RV016 as the main router, and 3 SRW224G4P switches for the network. W...
I have purchased 4 of these devices about 2 months ago and have experienced all of the issues reported within this thread. The came with the 2.0.0.5 FW rev installed, so unless the 2.0.0.5 on the cisco DL site is different, nothing I can do with tha...
Hi all, I have 3xWAP4410N APs that I'm using to cover most of our warehouse. Our neighbors right across the street have reported one of the APs flooding his AP with deauth commands. I'm guessing this has something with the rogue AP detection functio...
Good evening,i am trying to setup a VPN on WRVS4400N. the tunnel didnt come up, i used my public ip as the VPN peer and the LAN Private IPs on subnet 192.168.1.0/24 as the host IPs. After much troubleshooting, my client, that i am trying to connect t...
ok were using solarwinds network monitor and for some reason my WAP200E's are showing up as Tokyo Electric co devices and not cisco? Why would it be doing this?
Hello,i have three WAP200E, AP01 act as Master, AP02 and AP03 acting as repeater, all have the same last current Firmware.Repeating between AP02 and AP01 works fine, but repeating between AP03 and AP01 doesn't work successful. POE adapter of AP01 and...
My customer has about a dozen WAP200 access points. We are currently in the process of deploying IPv6 and we have hit upon a serious problem where the WAP200 forwards some untagged traffic from the ethernet into wireless SSIDs which should be bridgin...
Is there a firmware version that supports the N standard, not draft? The latest I see is 1.2.19 from Sep '09. If not, can I use the WAP4410N latest firmware?Thanks.
Hello everybody.Could someone help me with some deep technical questions regarding the AP541N access point?What I want to know is, if the AP has:- Watchdog per IP- ACK time adjusting- Site SurveyThank you all.Regards.Andrey Cassemiro.
Hi All,Anyone really good with WDS Bridging? I'm trying to successfully understand how WDS Bridging works with all the SB Pro hardware I have, and to get it working optimally. I have the following SB Pro hardware:1 x SA520W1 x ESW540 8P switch2 x A...
I tried to get higher speeds than 54MBits, displayed in Windows, which works without any problems for example on the D-Link DAP-2553, 130MBits are shown doubleclicking the WiFi-Adapter after successful connection on my client.My client is an Fujitsu...
So we bought a couple of these to test out, with the intentions to replace some dead WRT54GL access points and get some N wireless setup.setup so far has been easy but I am worried these things are going to be a bugger down the road to manage.My main...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: