Not really looking for confirmation about specific firmware in progress ( altho that would answer my question) .. question is really if Cisco is still supporting this version such that they would be developing any new/maintenance releases of firmware for this model .. ? The latest release seems to have stabilized the product and resolved a few issues , but .. for the longer term ...
the v1 and v2 are still supported and not end of life as of yet. You can expect Cisco to continue to develop on the products until they are listed on the end of life/ end of sale/ end of support web page. Only after the products are listed as end of life will the firmware cease to be updated.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...