Ok, im using RV320, SG200-50, and 2xWAP320's, I'm trying to use captive portal on VAP2 ONLY (guest wifi) The IP will get passed to the guest device but will never go to the auth page HOWEVER if i use the VAP1 and set the instance association it works on vap1, Sooo what am I doing wrong. Ive heard on different fourms that its not built to work correctly w/o management vlan access? Due to the environment I am installing this the vlans MUST be seperate. Does anyone know something I don't?
Im using the default vlan setup which is 1-Default, 25-Guest, 100-Voice.
Port Vlan Membership = General , 1UP/25T , 1UP/25T
Port1 on switch = RV320
Port49 = WAP1
Port50 = WAP2
Single Point Setup
captive portal setup by the guest wizard
I have updated the firmware on all devices and downgraded to different firmware's on the WAPs, Reset, Reconfigured, Factory defaulted, etc etc.
With the latest release of firmware for the WAP 561, 551, 371, 351 a new
feature was added that would allow customers to upgrade the firmware for
their clustered access points from the main access point.The basic steps
to accomplish this is:1) Download th...
Special thanks to Alex McDonald for sharing his favorite tip:My favorite
tip is the ‘write default’ command on autonomous wireless access points,
it simplifies manual conversion of a WAP with a static ip address to a
LAP with a DHCP address.This saved a l...