Cisco Small Business WAP 321 POE Injector Power Input & Output
I have purchased three small business WAP321 without any power adapter and POE injector. basically there is no adapter and POE injector comes with it, i had to buy separately TENDA POE injector which is available in my country Bangladesh. it is associate with 51 Volt & 30 watt and 0.8 Amp
within 3 hours two of my WAP321 permanently damaged by the POE Injector. so i would like to request what exact power of POE injector i should use to avoid this type of scenario,my length of network cable was around 30 miter. i don't want to use Power Adapter. Kindly need support in this regards.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...