Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CISCO WAP200 after reset will not accept default id/pswd

   I had to reset the WAP200 wireless device expecting that it would then allow access using the default id/pswd of admin.  Unfortunately, I am not able to gain access to the setup GUI as it does not recognize the default id of admin and pswd of admin.  I reset the device twice with the same result.  The device warranty ran out in 2012 as it was purchased back in 2009.

Any pearls of wisdom so I can gain access?     

Best Regards         

Everyone's tags (1)
2 REPLIES
Green

CISCO WAP200 after reset will not accept default id/pswd

Hi Kevin, can you verify how you reset this unit? Hold the reset button in for like 35-40 seconds.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Gold

CISCO WAP200 after reset will not accept default id/pswd

Kevin,

Is the AP plugged into your network or do you just have a PC plugged directly into it with a static IP? I would give the PC a static 192.168.1.200/24, no gateway. Reset as Tom suggested and then log in using admin/admin.

- Marty

685
Views
0
Helpful
2
Replies
CreatePlease to create content