We are using a Cisco WAP4410 access point for our business and since yesterday the device is not responding. We have tried disconnecting the power and then re-connecting it. We have tried different network cables and also tried to reset the device by pressing the reset button for 10 seconds. When the device is powered on the power light blinks and the Ethernet light is on after about 30 minutes the power light is solid green along with the Ethernet light however we cannot ping the device on 192.168.1.245 as well as the device is not grabbing an IP address. The Ethernet LED is not responding when we disconnect the Ethernet cable its just solid green. Please advice on this situation. I am attaching the device specific information below:
Model: WAP4410N Serial NO: SER133601FL MAC Address: 001562FFDAA6 PIDVID: WAP4410N-A V01
We have about 20 employees that need wireless access. Your help is much appreciated.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...