Cisco Wireless-N Bridge for Phone Adapters firmware update problem
I have a Cisco Wireless-N Bridge for Phone Adapters. I decided to update firmware on the device. I downloaded it from official Cisco web site download page. Then I just logged in to the device and initiated update procedure. I waited good amount of time allowing the device to install new firmware.
Now the Wireless Bridge will not boot. Once powered up System LED will flash green for 15 seconds. Then it will become amber and will flash with higher frequency forever.
I tried to factory reset it, but it gives no result - same behavior remains.
As a note - I updated exactly same device with exactly same firmware just before I did this one and it went good - so firmware is not a reason for this behavior.
Can anyone advice me on what I can do to bring life to this device?
Get to Know the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE Local Area Network (LAN) delivers secure and reliable wireless connectivity. It ...
Product Specifications of the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN delivers secure and reliable wireless connectivity. It allows you t...
Configure the Single Point Setup on the WAP581
A Wireless Access Point (WAP) connects to a router and serves as a node to the Wireless Local Area Network (WLAN). Clustering is when multiple WAPs are joined on the same netwo...