Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

configure cmd not available for 1131ag access point

I have connected to my new 1131ag access point with a serial cable and hyperterminal and am able to get a list of commands.

I enter "enable" and my password to get a list of more commands.

But at this point there is not "configure" command available as is stated in the documentation.

Also, this device is plugged into a local network and has been assigned an IP address from DHCP. When I try to connec to that address in my browser it does connect to anything.

Is there something I have missed that I need to do to be able to configure this access point via the console interface or the browser interface?

2 REPLIES
Silver

Re: configure cmd not available for 1131ag access point

Hello,

Thanks for posting. Since this is not a small business product, I suggest posting this question in the Cisco NetPro Community http://forum.cisco.com/eforum/servlet/NetProf?page=main for input from appropriate subject matter experts. NetPro is a peer and expert forum where you can get suggestions and information from networking professionals on a variety of solutions and technologies.

Let me know if you have any questions.

Cindy Toy

Cisco Small Business

Support Community Manager


Regards, Cindy If my response answered your question, please mark the response as answered. Thank you!
New Member

Re: configure cmd not available for 1131ag access point

I have done that.

Thanks

2173
Views
0
Helpful
2
Replies