Devices keep disconnecting from WAP300N connected to RV180 Router
We are a small business and we are using WAP300N as an access point to which about 40 devices are connecting daily. The AP is connected to a RV180 Multifunction VPN Firewall Router. Since we have this infrastructure, every single day there are clients who are been disconnected and cannot reconnect for a while until we disconnect another device.
The router has been set up as a DHCP server with a pool 192.168.1.2 - 192.168.1.127. However, I set up all clients with a static IP outside the pool.
The access point has the following settings:
Network Name (SSID):
20 MHz Only
The routing mode of the Router is set to Gateway (NAT). Can you please advice what can be done so we can resolve the issue? I saw similar posts in the forum but none of them provide solutions.
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...