Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Excessive Hold Time When Contacting SBSC

I gave up. While on hold two hours, just to speak with a tier 1 tech, I've been reading other forums on this product, leaving my bad reviews.  No matter where you go, almost every one seems to be having the same issue. Several people on different forums mentioned great luck with the D-Link's AirPremier N Dual Band Access Point DAP-2553, PoE support, multiple SSID, 802.1Q VLA.

Looking into it I noticed that is have a great sale on them until 9/30. Picked up two of them for $79 each. Normaly $160 each. I'll eat the cost and try to sell the wap4410n's on ebay to re-coup. I rather eat the cost of new AP's then loose a good client over this.

Epic fail Cisco.

Cisco Employee

Re: WAP4410N stops responding

Hi Channing - Thanks for your post. Can you please provide your case number as well as the number you dialed when you were left on hold? It is definitely not the Cisco policy to leave customers on hold for that length of time so I'd like to investigate your case.

Thank you in advance,

Stephanie Reaves

Cisco Small Business Technology Group

New Member

Re: WAP4410N stops responding

Too late and a dollar short. I've already replaced the WAP4410N"s with D-Link DAP-2553's and not only do they do every thing that the Cisco/Linksys device does, they signal strangth is better and there hasn't been any need to re-boot them every day.I hope I can sell the WAP4410N's on ebay!

As for the case #, I wasn't on hold, I was just waiting to get to the next available tech support. Maybe you should hire more tech support so your clients don't have to wait an hour or more just to speak with tier one support.