Hello, I would like assistance with the parameterization of a Cisco SG200-18 switch. Indeed I would like to create three separate VLANs to distribute from the internet to three companies that do not have to interact in it or with my personal network, I successfully created these three vlan, I limited the flow on the 3 Ports I wish to register with these three companies (1 port per company with 1 reserved network address) and thus have three separate network addresses for these three companies but I can not go further in the procedure.When I try to Change the subnet mask of the switch the interface gele .... I give you some information about my network: ip address of the switch = 192.168.1.253 mask = 255.255.255.0. Ip address of my router = 192.168.1.254 Network address of my network = 192.168.1.0 mask = 255.255.255.0 (which can not be parameterized) Could you guide me in this setting please. In advance thank you to you I leave you my email address and my tel number for your information phone number = 06.44.97.28.13 mail = email@example.com Regards, Stéphane G
It sounds like you need to create 3 separate SVIs (Switch Virtual Interface) on this device. If this is the case, I'm afraid that your device is only a layer 2 switch which does not support this feature and you will need a different L3 switch (such as SG300 or others) or a L3 device which supports this feature. With your current switch you can still create 3 separate VLANs and assign ports to be members of these VLANs, however you will need to have an Interface for each of these VLANs which will need to be on a different device.
Hello and thank you for your answer this will help me, actually after studying the switch it appears that it is not suitable for this kind of project Thank you again for your help on this subject. Good day to you Stephane G
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...