I use a WRVS4400Nv2 router with firmware V1.00.09-ETSI.
I've noticied in the status pages that the router has 2 IP address. The first is associated to the LAN interface and the second to the WLAN interface. I can easily change the IP on LAN interface in the Setup/LAN page but I cab't found a way to change the IP address associated to the WLAN interface ?
On the Setup/LAN page, the LAN IP can be changed with the "Local IP Address" settings. Below, there is on option called "IP Reserved for Internal Usage". This is in fact the IP used for WLAN interface. I've changed it, saved settings and checked on Status/Wireless LAN page and this is the right settings.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...