Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How to configure Authentication-Type = PEAP on Cisco Rv 120W

I am configuring Cisco RV 120W Wireless and want to setup WPA2 Enterprise with PEAP. However, I can't figure out where to setup PEAP. Can someone elp?

1 REPLY
Bronze

How to configure Authentication-Type = PEAP on Cisco Rv 120W

Dear Customer,

Thank you for reaching the Small Business Support Community.

The RV120W supports Port-based RADIUS authentication (Extensible Authentication Protocol [EAP], Protected EAP [PEAP]).  Please refer to page 109, chapter 5, for RADIUS configuration settings guidelines (those are the only RADIUS available configurable settings);

http://www.cisco.com/en/US/docs/routers/csbr/rv120w/administration/guide/rv120w_admin.pdf

Please check on the below threat where someone inquired about some known issue;

https://supportforums.cisco.com/message/3697817#3697817

If you require further assistance I suggest you to contact support directly;

https://supportforums.cisco.com/community/netpro/small-business/sbcountrysupport

Please do not hesitate to reach me back if there is any further assistance I may help you with in the meantime.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
401
Views
0
Helpful
1
Replies
CreatePlease to create content