Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Need some advice for AP IOS upgrade (Wireless Access Point 3702 Series) ?

Hi to all

 

I recently purchase a Wireless Access Point (AIRCAP 3702E-E) with 4 antenna, i will use this device like wifi hotspot in my home.

I would like to upgrade it but i see two kind of AP IOS :

  • Lightweight AP IOS Software
  • Autonomous AP IOS

What are the difference ?

 

In case of Lightweight AP IOS Software will be the one to choose, i have multiple IOS :

  • Wireless Lan, ap3g2-k9w8-tar.152-4.JB4.tar
  • Wireless Lan Recovery, ap3g2-rcvk9w8-tar.152-4.JB4.tar

 Someone can tell me what is the difference between these two versions ?

Best Regards.

 

Elrick.

 

 

5 REPLIES
New Member

Hi Elrick, Cisco AP

Hi Elrick,

 

Cisco AP AIRCAP3702E is Cisco enterprise unit.  Cisco small business support WAP4410N, WAP121, WAP321, WAP551, and WAP561 AP. However I will answer your questions.

Lightweight AP ISO you can use it ONLY if you connect AP to wireless controller

Autonomous AP ISO for manage and modify AP  by it self not required wireless controller.

 

 

 

Thanks,

Moh

New Member

Hi, Many thks, so the

Hi,

 

Many thks, so the Autonomous release is the good one for me.

I just install it.

 

I would like to link my AP to my Cisco router, do you know where i can get some info for a correct setup ?

 

Regards.

New Member

Hi Elrick, Do you know your

Hi Elrick,

 

Do you know your router mode?

 

Thanks,

Moh

New Member

My router is a 2821.

My router is a 2821.

New Member

Hi Elrick,this is correct

Hi Elrick,

this is correct support community forums for routers

https://supportforums.cisco.com/community/5991/wan-routing-and-switching

here support community forums for AP

https://supportforums.cisco.com/community/4931/wireless-mobility

I know how to config your router and AP however I am in different department.

Thanks,

Moh

581
Views
0
Helpful
5
Replies
CreatePlease to create content